Arc resistance

Then it considers the influence when the arc resistance is large .

进一步考虑了电弧电阻较大时，电弧炉系统对供电网的影响。

The application of 8031 microprocessor in testing device of geyser arc resistance

8031单片机在间歇式耐电弧试验仪中的应用

After that the derived new time-varied arc resistance model was put into the electrical system model to make simulation .

最后，将得到的交流电弧时变电阻模型代入交流电弧炉电气系统的数学模型进行了仿真验证。

Solid electric insulating materials & Test methods of high-voltage small-current intermittent arc resistance

GB/T1411-1978固体电工绝缘材料高压小电流间歇耐电弧试验方法

Inquisition of Lightning Protection and Arc Resistance Performance of Steeled Glass Insulator

钢化玻璃绝缘子耐雷和耐电弧性能的探讨

It has excellent electric leakage resistance and arc resistance , have simultaneously certain impact and heat-resistance .

具有优良的耐漏电性和耐电弧性，兼具一定的抗冲击性和耐热性。

The improved injection mold technology and talc filler are of help to increase die arc resistance of the composites .

另外改变加工工艺或添加滑石粉也可提高材料的耐电弧性。

Arc Resistance of Amylum Modified Polypropylene

淀粉改性聚丙烯耐电弧特性的研究

However the electrode regulator has been generally designed based on the linear arc resistance model for long , of which the control effect is actually not perfect .

然而长久以来，为了简化电极控制器的设计，人们一般基于线性电弧阻抗模型来设计控制器，其实际控制效果并不理想。

From the power quality point of view , the arc resistance is nonlinear , which can be considered as a harmonic source will reduce the quality of power .

从电能质量的观点来说，由于电弧电阻是非线性的，电弧可以认为是一个谐波源，电弧的产生会降低供电质量。

For the arc resistance is nonlinear and high , the conventional feeder protections , such as impedance protection and current protection , maybe fail to trip off .

由于电弧电阻非线性、时变性、高阻的特点，使得常规原理馈线保护中的阻抗保护、电流速断保护往往不能正确动作。

The combined properties of the material , such as density , hardness , resistivity , arc resistance and temperature characteristics , are similar to those of conventional silver contact materials .

该材料的综合性能，如密度、硬度、电阻率、灭弧特性及温度特性与传统的银基触头材料接近。

In the method of average resistance , the average arc resistance is determined directly by the experimental fitting equation on the initial gas pressure , the arc resistance , the initial density of electrical energy .

其中平均电阻法直接由电弧电阻与充气压力、初始电能密度的实验拟合公式确定电阻；

With the progress of science and technology , mechanical properties , electric properties , arc resistance , thermal conductivity and flame retardant performance of the printed circuit laminate have been proposed to higher requirements .

科技的发展对印制电路用层压板的力学性能、电性能、耐电弧性、热导率以及阻燃性能提出了更高的要求。

This paper gives a review of the effect of turbulence on the interrupting performance of the gas blast circuit breakers from various aspects , such as total arc resistance , specific arc resistance , interrupting current limit and dielectric strength recovery .

本文从总弧电阻、比电阻、极限开断电流、介质恢复强度等方面评述了紊流对气吹断路器开断性能的影响。

Experimental Study on Arc Ablation Resistance and Dielectric Property of PTFE Composites

复合聚四氟乙烯耐电弧烧蚀及其介电性能的试验研究

Results show that the fiber-structured W / Cu contact has better arc erosion resistance than the contact made by powder metallurgy method .

与粉末冶金制造的W/Cu触头材料的烧蚀性能作对比，从触头表面在电弧烧蚀后的熔层形貌分析表明，纤维结构W/Cu触头材料呈现较好的抗烧蚀特性。

Furthermore the main influence factors in post arc fulgurate resistance were also studied , which was useful to give an optimal design of a fuse .

研究了影响弧后残躯电阻的主要因素，以便确定出最佳工作状态，为优化设计提供可靠的依据。

These studies on arc erosion resistance mechanisms can provide a scientific basis for arc extinguishing researches and their practical applications of resin-type contact strip .

此抗电弧侵蚀机理为树脂型滑板材料的抑弧研究和实际应用提供了科学依据。

According to the results of finite element analysis and the temperature measurement of the tested pantograph pan , the effects of different heat sources caused by electric arc , contact resistance and friction were studied systematically on various pantograph pan materials .

文章采用有限元计算与实测温升相结合的分析方法，系统研究了不同热源（包括电弧热、接触电阻热、摩擦热以及体电阻热）对各种滑板材料体温升的影响。

Short circuit impedance of arc furnace installation The resistance wire in an electrical appliance such as a heater or an oven .

电弧炉设备的短路阻抗如加热器或灶具等电气设备中的阻抗电丝。

As the main equipment of ferroalloy production , submerged arc furnace heats up raw materials through the arc heat and resistance heat , so that reduction reactions can take place under certain temperatures to produce ferroalloy production .

矿热炉是生产铁合金的主要设备，通过三相电极产生的电弧热和炉料的电阻热熔化矿石，使炉料在一定温度下发生还原反应，冶炼出所需铁合金产品。

At present , the arc contacts in SFe switches is formed by the excellent property of electrical arc resistance of Cu W alloy and the eminent conductivity together with high elasticity of CrCu alloy , so-called CuW / CrCu integrated contact .

目前在SF6断路器中普遍使用的触头材料一般由耐电弧烧损的CuW部分和提供弹性和导电性的CrCu部分组成，即CuW／CrCu整体触头。

Starting from solving the power balance non-linear differential equation for the electric arc with the arc radius as a state variable , instead of regarding the arc resistance as a constant , the relationship of arc current and arc radius is obtained .

与以往基于电弧阻抗的电弧炉模型不同，该模型从电弧炉的电弧能量方程出发，以电弧半径作为状态变量通过解非线性方程求出电弧半径与电流的关系。

The submerged arc furnace ( SAF ) is used to convert the high-voltage electric energy to arc heat and charge resistance heat to meet the heat needs of silicon-manganese ferroalloy smelting .

硅锰铁合金埋弧炉将高压电能通过供电系统转换为熔池电弧热能和炉料电阻热能，以满足铁合金熔炼需要的热量。